Universal R-320 Návod k obsluze stáhnout pdf (Strana 23)

ADJUSTING THE LABEL HEIGHT OF THE L-15

Run one test container. Look at the label placement in reference to the height.

If the label is too high, turn the applicator height adjust crank handle

clockwise to lower the unit. If the label is too low, turn the crank handle

counter clockwise to raise the unit. (See Fig.22)

CHECKING LABEL SKEW

After the height of the label is adjusted to the container, check the skew of the

label by comparing the leading edge of the label to the trailing edge of the

label. The leading edge is the part of the label that was applied first. The label

below is skewed down. (See Fig.23)

Fig.22

Applicator Height

Adjust Crank

Handle

Fig.23

Leading Edge

Trailing Edge

Leading Edge of

Label is higher

than Trailing

Edge.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 68 69

Žádné komentáře

Universal R-320 Návod k obsluze Strana 23